Install Guide
1. Disconnect Power
Turn off the car and disconnect the negative battery terminal to avoid short circuits while you work.
2. Mount the Speaker
Remove the old speaker. Match the new speaker to the cutout and secure with screws (use mounting bracket if needed).
3. Connect and Test
Wire positive to positive and negative to negative. Reconnect battery and test sound. Adjust EQ for best clarity.
Common Questions Before You Buy
How much power do they handle?
100W power output with 4 ohm impedance, suitable for most factory and aftermarket car stereos and amplifiers.
Which size should I pick?
Match your existing speaker cutout. 4 inch is common for dash, 5 inch for door, 6.5 inch for door or rear. Measure before buying.
Is it sold as a pair or single?
Each variant is sold as 1 piece (single speaker). Order 2 if you want a stereo pair.
Will they survive Australian summer heat?
Yes. The moisture resistant PP rubber surround and injection molded diaphragm hold up well in hot, humid car interiors.
Do I need an amplifier?
Not required. They work with most car head units, but an amplifier will deliver maximum performance and louder, cleaner sound.



100W power output with high density coaxial magnets
